Poster + Presentation + Paper
10 October 2020 A location error calibration method for multiple probing systems
Sen Zhou, Jian Xu, Tao Lei, Yu Yan, Liu Tong
Author Affiliations +
Conference Poster
Abstract
A CMM with multiple probing systems have the power to deliver tremendous benefits to most notably manufacturing, and have the advantage of high automation, high integration and high precision. According to the ISO standard 10360-9, multiple probing system location error should be identify and calibrated before use. In this paper, a location error self-calibration model was established based on a composite artifact. The location error of individual probing system can be respectively determined reference to the position of the probe configuration. An error separation procedure was introduced to correct this location error. A series of representative experiments were performed on a commercial combined probing system produced by our partner. The experimental results show that multiple probing systems location error was effectively reduced from 4.5μm to2.8μm. Also, this calibration evaluation is very apparently practical outside a laboratory due to its simple, portable, low-cost, and rational procedure.
Conference Presentation
© (2020) COPYRIGHT Society of Photo-Optical Instrumentation Engineers (SPIE). Downloading of the abstract is permitted for personal use only.
Sen Zhou, Jian Xu, Tao Lei, Yu Yan, and Liu Tong "A location error calibration method for multiple probing systems", Proc. SPIE 11552, Optical Metrology and Inspection for Industrial Applications VII, 1155212 (10 October 2020); https://doi.org/10.1117/12.2572686
Advertisement
Advertisement
RIGHTS & PERMISSIONS
Get copyright permission  Get copyright permission on Copyright Marketplace
KEYWORDS
Calibration

Composites

Curium

Standards development

Error analysis

Imaging systems

Inspection

Back to Top