Paper
17 April 2013 Effects of fastener load on wave propagation through lap joint
Author Affiliations +
Abstract
Experimental results on the propagation of guided waves through a bolted joint under various bolt load values are presented. Piezoelectric wafer active sensor (PWAS) transducers are used for the generation and reception of the guided waves. Two specimen types are used, a strip lap joint and a plate lap joint. The signals measured under various bolt load values and frequency values are studied in order to identify relevant features that change drastically with bolt load. We found that some of the signals, especially those at S0 tuning frequency of 320 kHz, were very much simplified by the change from strip to plate conditions. The main contribution of this paper to the advancement of the state of the art consists in highlighting the need for removing the confounding effects of the strip side reflections on the correct interpretation of guided wave changes as they travel through a lap joint with various fastener loads.
© (2013) COPYRIGHT Society of Photo-Optical Instrumentation Engineers (SPIE). Downloading of the abstract is permitted for personal use only.
Jingjing Bao and Victor Giurgiutiu "Effects of fastener load on wave propagation through lap joint", Proc. SPIE 8695, Health Monitoring of Structural and Biological Systems 2013, 869521 (17 April 2013); https://doi.org/10.1117/12.2012185
Lens.org Logo
CITATIONS
Cited by 2 scholarly publications.
Advertisement
Advertisement
RIGHTS & PERMISSIONS
Get copyright permission  Get copyright permission on Copyright Marketplace
KEYWORDS
Wave propagation

Waveguides

Sensors

Wave plates

Aluminum

Transducers

Receivers

Back to Top