2 August 1982 Design Approach For A Thermally Compensated Injection Laser Stack Transmitter/Receiver
Author Affiliations +
Proceedings Volume 0317, Integrated Optics and Millimeter and Microwave Integrated Circuits; (1982) https://doi.org/10.1117/12.933093
Event: Integrated Optics and Millimeter and Microwave Integrated Circuits, 1981, Huntsville, United States
Abstract
A thermal analysis has been completed on an injection laser stack based on the electrical power dissipation within the laser stack material during operation. The thermal gradient existing in the laser stack during operation can cause large wavelength variations among individual lasers of the stack if certain fabrication procedures are not followed. For a given electrical power dissipation, a "monochromatic" injection laser stack can be designed (i.e., the spectral peaks of all lasers within the stack being at the same wavelength). A prescription for laser diode preselection prior to fabrication is given. The dominant source of temperature variations within the stack is electrical resistance non-uniformities of solder connections, causing non-uniform heating of the laser stack during a current pulse. Results of an experiment for measuring the temperature distribution of the injection laser stack after a single pulse are described which demonstrate electrical resistance non-uniformities within the stack. Finally, the minimum receiver filter spectral bandwidth corresponding to this thermally compensated injection laser stack is calculated.
© (1982) COPYRIGHT Society of Photo-Optical Instrumentation Engineers (SPIE). Downloading of the abstract is permitted for personal use only.
Mark D. Skeldon, Mark D. Skeldon, } "Design Approach For A Thermally Compensated Injection Laser Stack Transmitter/Receiver", Proc. SPIE 0317, Integrated Optics and Millimeter and Microwave Integrated Circuits, (2 August 1982); doi: 10.1117/12.933093; https://doi.org/10.1117/12.933093
PROCEEDINGS
11 PAGES


SHARE
Back to Top