Paper
5 April 1983 Specular Spectral Reflectance Of ALS1304 Stainless Steel At Near-Normal Incidence
Yoshiharu Namba
Author Affiliations +
Abstract
A study has been performed experimentally to determine the effects of surface roughness, damaged surface layer and chemical composition on the specular spectral reflectance of A1SI304 austenitic stainless steel from the machining point of view. Stainless steel samples are heat-treated under various conditions and polished by various methods. Flat samples are polished supersmoothly to a surface roughness of 20 angstroms Rz by terminating the damage-free polishing of the damaged surface layer at a point prior to the appearance of the grain boundary due to crystallographic anisotropy. The reflectance is strongly dependent on wavelength and surface roughness and increases as damage to the surface layer decreases. The combination of adequate annealing and special polishing is useful to produce higher reflectance on metal substrates. Surface chemical composition profiles are measured by ILIA and ALS, which show that chromium is depleted at the very topmost oxidized layer on the polished sample, while there is a chromium-rich oxide layer beneath the layer. The thickness of the oxide layer is about 30 angstroms on the supersmoothly polished stainless steel.
© (1983) COPYRIGHT Society of Photo-Optical Instrumentation Engineers (SPIE). Downloading of the abstract is permitted for personal use only.
Yoshiharu Namba "Specular Spectral Reflectance Of ALS1304 Stainless Steel At Near-Normal Incidence", Proc. SPIE 0362, Scattering in Optical Materials II, (5 April 1983); https://doi.org/10.1117/12.934138
Lens.org Logo
CITATIONS
Cited by 5 scholarly publications.
Advertisement
Advertisement
RIGHTS & PERMISSIONS
Get copyright permission  Get copyright permission on Copyright Marketplace
KEYWORDS
Surface finishing

Polishing

Reflectivity

Surface roughness

Diamond

Oxides

Visible radiation

RELATED CONTENT

Beamsplitter material comparison: KBr and ZnSe
Proceedings of SPIE (October 20 1999)
Advances in photonic MOEMS-MEMS device thinning and polishing
Proceedings of SPIE (February 16 2010)
Computer-controlled fabrication of free-form glass lens
Proceedings of SPIE (November 11 1999)
Growth, polishing, and optical scatter of diamond thin films
Proceedings of SPIE (December 01 1990)
Beryllium galvanometer mirrors
Proceedings of SPIE (September 01 1991)

Back to Top