11 December 1985 Automated Measurement and Gaging Using Industrial Robots
Author Affiliations +
Proceedings Volume 0579, Intelligent Robots and Computer Vision IV; (1985) https://doi.org/10.1117/12.950797
Event: 1985 Cambridge Symposium, 1985, Cambridge, United States
Abstract
This paper describes a current research which involves the development of a special end effector and the necessary algorithms to perform inspection and gaging tasks using tactile sensing. The special end effector, which has a mechanical probe performs these operations by using adaptive contact and continuous measurement of forces to determine the locations and the dimensions of the holes to be inspected. This will provide a flexible and relatively inexpensive means of inspection when extremely high accuracies are not desired.
© (1985) COPYRIGHT Society of Photo-Optical Instrumentation Engineers (SPIE). Downloading of the abstract is permitted for personal use only.
Ezat T. Sanii, Ganesh R. Kalbavi, "Automated Measurement and Gaging Using Industrial Robots", Proc. SPIE 0579, Intelligent Robots and Computer Vision IV, (11 December 1985); doi: 10.1117/12.950797; https://doi.org/10.1117/12.950797
PROCEEDINGS
6 PAGES


SHARE
RELATED CONTENT

Finger Based Explorations
Proceedings of SPIE (March 27 1987)
High-Level Planning And Low-Level Control
Proceedings of SPIE (February 19 1988)
Distributed Control In The Multi-Sensor Kernel System
Proceedings of SPIE (January 17 1985)
New Directions In Multi-Sensor Fusion
Proceedings of SPIE (March 27 1989)
Fuzzy logic for fault diagnosis
Proceedings of SPIE (February 01 1991)

Back to Top