24 September 1986 Low Cost Selective Absorber Based On A Fe-Al203 Cermet Film
Author Affiliations +
Abstract
The absorber-reflector tandem configuration is used for the realization of a selective absorbing surface for the photothermal conversion of solar energy. The infrared reflector consists of a stainless steel substrate, covered or not with a W or Mo thick film. The visible absorbing function is realized by a thin, low cost, Fe-A1,0, cermet film. The cermet films are prepared by R.F. co-sputtering onto a rotating stainless steel substr'te. The target consists of a circular Al203 plate covered with small discs, the concentration varying with the Fe disc number. The optical properties of the thin Fe-Al203 are studied as a function of the Fe volume fraction from 0.2 to 0.9. The dielectric function is calculated from the reflectivity and transmittivity measurements in the 300-50.000 nm spectral range. The films exhibiting the required selective properties : high absorptivity in the visible, high transparency in the infrared, are selected. A sandwich, composed of a thin Al203 antireflecting film, the cermet film (with adequate thickness and composition) and the reflecting substrate, exhibits a good selectivity for the photothermal conversion at low and middle temperatures.
© (1986) COPYRIGHT Society of Photo-Optical Instrumentation Engineers (SPIE). Downloading of the abstract is permitted for personal use only.
C Sella, C Sella, A Kaba, A Kaba, S Berthier, S Berthier, J Lafait, J Lafait, } "Low Cost Selective Absorber Based On A Fe-Al203 Cermet Film", Proc. SPIE 0653, Optical Materials Technology for Energy Efficiency and Solar Energy Conversion V, (24 September 1986); doi: 10.1117/12.938330; https://doi.org/10.1117/12.938330
PROCEEDINGS
7 PAGES


SHARE
RELATED CONTENT


Back to Top