Translator Disclaimer
13 February 1987 A Method For Orthogonal Cutting Experiments With Diamond Tools
Author Affiliations +
Abstract
This paper describes an experimental set-up to perform cutting tests on different materials using single-crystal diamond tools. The method uses a plunge cut into the edge of a rotating disk to approach two-dimensional or orthogonal cutting at realistic cutting speeds. Preliminary results of this method are reported.
© (1987) COPYRIGHT Society of Photo-Optical Instrumentation Engineers (SPIE). Downloading of the abstract is permitted for personal use only.
Richard L Rhorer "A Method For Orthogonal Cutting Experiments With Diamond Tools", Proc. SPIE 0676, Ultraprecision Machining and Automated Fabrication of Optics, (13 February 1987); https://doi.org/10.1117/12.939524
PROCEEDINGS
5 PAGES


SHARE
Advertisement
Advertisement
RELATED CONTENT

Wear Test Of A Preselected Diamond Tool
Proceedings of SPIE (February 13 1987)
Diamond Turning Optical Surfaces On Electroless Nickel
Proceedings of SPIE (October 27 1978)
Holography and the landscape tradition
Proceedings of SPIE (January 12 1994)
Quantitative comparison of shot boundary detection metrics
Proceedings of SPIE (December 17 1998)
Tribological Considerations Of The Diamond Single-Point Tool
Proceedings of SPIE (December 11 1984)

Back to Top