14 December 2016 Influence of spray nozzle shape upon atomization process
Author Affiliations +
Proceedings Volume 10010, Advanced Topics in Optoelectronics, Microelectronics, and Nanotechnologies VIII; 100101L (2016) https://doi.org/10.1117/12.2243130
Event: Advanced Topics in Optoelectronics, Microelectronics, and Nanotechnologies 2016, 2016, Constanta, Romania
Abstract
The atomization process is affected by a number of operating parameters (pressure, viscosity, temperature, etc.) [1-6] and the adopted constructive solution. In this article are compared parameters of atomized liquid jet with two nozzles that have different lifespan, one being new and the other one out. The last statement shows that the second nozzle was monitored as time of operation on the one hand and on the other hand, two dimensional nozzles have been analyzed using laser profilometry. To compare the experimental parameters was carried an experimental stand to change the period and pulse width in injecting liquid through two nozzles. Atomized liquid jets were photographed and filmed quickly. Images obtained were analyzed using a Matlab code that allowed to determine a number of parameters that characterize an atomized jet. Knowing the conditions and operating parameters of atomized jet, will establish a new wastewater nozzle block of parameter values that can be implemented in controller that provides dosing of the liquid injected. Experimental measurements to observe the myriad forms of atomized droplets to a wide range of operating conditions, realized using the electronic control module.
© (2016) COPYRIGHT Society of Photo-Optical Instrumentation Engineers (SPIE). Downloading of the abstract is permitted for personal use only.
Marius Beniuga, Ioan Mihai, "Influence of spray nozzle shape upon atomization process", Proc. SPIE 10010, Advanced Topics in Optoelectronics, Microelectronics, and Nanotechnologies VIII, 100101L (14 December 2016); doi: 10.1117/12.2243130; https://doi.org/10.1117/12.2243130
PROCEEDINGS
8 PAGES


SHARE
Back to Top