14 December 2016 Heat transfer at the sintered layer-polysynthetic material interface inside heat micro pipes
Author Affiliations +
Proceedings Volume 10010, Advanced Topics in Optoelectronics, Microelectronics, and Nanotechnologies VIII; 100101P (2016) https://doi.org/10.1117/12.2243148
Event: Advanced Topics in Optoelectronics, Microelectronics, and Nanotechnologies 2016, 2016, Constanta, Romania
Abstract
If micro heat pipe heat transfers, the inside working fluid goes through a biphasic state. The flow of the liquid and the vapor thereof by the capillary beds of frittered copper and the layer of capillary polysynthetic material and migration of vapors liquid from the end, takes the heat flow towards the end where a transfer of heat may occur only if there is a difference in temperature between the end of a flat micro heat pipe that gives the acquirer heat and heat flux. The porosity of the material is total pore of the total material volume. In the analysis of heat and mass transfer through porous media, both convective and conductive transfer forms can not be separated, because of the surfaces in contact between the two capillar layers. It had been studied the dependence of the rate of flow of liquid through the frittered porous media, and Reynolds polysynthetic. It tracks changes in the Reynolds number based on the interior capillary porosity. They traced in Mathcad [1] the graphs for changing the Reynolds number of capillary pressure by capillary porosity.
© (2016) COPYRIGHT Society of Photo-Optical Instrumentation Engineers (SPIE). Downloading of the abstract is permitted for personal use only.
Siviu Sprinceana, Ioan Mihai, "Heat transfer at the sintered layer-polysynthetic material interface inside heat micro pipes", Proc. SPIE 10010, Advanced Topics in Optoelectronics, Microelectronics, and Nanotechnologies VIII, 100101P (14 December 2016); doi: 10.1117/12.2243148; https://doi.org/10.1117/12.2243148
PROCEEDINGS
7 PAGES


SHARE
Back to Top