28 September 2016 Simulation and optimization of physical phenomena when engine block machining: case study
Author Affiliations +
Proceedings Volume 10031, Photonics Applications in Astronomy, Communications, Industry, and High-Energy Physics Experiments 2016; 100310O (2016) https://doi.org/10.1117/12.2249389
Event: Photonics Applications in Astronomy, Communications, Industry, and High-Energy Physics Experiments 2016, 2016, Wilga, Poland
Abstract
Paper presents researches of cutting force measurements and computer simulation of physical phenomena existing in the cutting zone. Stress distributions in the upper layer after machining were calculated with the numerical software, basing on the FEM method. Optimization of turning process was realized for the purpose to minimize the cutting force and stress values during stainless steel machining, belonging to the difficult-to-cut materials group.
© (2016) COPYRIGHT Society of Photo-Optical Instrumentation Engineers (SPIE). Downloading of the abstract is permitted for personal use only.
Wojciech Zębala, Grzegorz Struzikiewicz, Ksenia Rumian, Małgorzata Plaza, "Simulation and optimization of physical phenomena when engine block machining: case study", Proc. SPIE 10031, Photonics Applications in Astronomy, Communications, Industry, and High-Energy Physics Experiments 2016, 100310O (28 September 2016); doi: 10.1117/12.2249389; https://doi.org/10.1117/12.2249389
PROCEEDINGS
8 PAGES


SHARE
RELATED CONTENT

Study on lateral buffer generation in GIS
Proceedings of SPIE (August 07 2007)
Research on the dq coordinate transform in the six phase...
Proceedings of SPIE (October 30 2006)
Data-dependent tetrahedrization
Proceedings of SPIE (September 30 1996)
SWOTs methodology for digital urban planning
Proceedings of SPIE (October 28 2006)

Back to Top