Translator Disclaimer
Presentation + Paper
16 February 2017 Flexible thin polymer waveguide Bragg grating sensor foils for strain sensing
Author Affiliations +
This paper demonstrates that epoxy-based single mode polymer waveguides with Bragg gratings can be realized in very thin (down to 50 micron) polymer foils which are suitable for strain sensing when integrated inside glass fiber reinforced polymer composite materials. The single mode waveguides were fabricated using laser direct-write lithography and the gratings were realized using nanoimprint lithography. These steps were performed on a temporary rigid carrier substrate and afterwards the functional layers were released yielding the thin, flexible sensor foils which can be laser-cut to the required dimensions. The Bragg grating-based polymer waveguide sensor foils were characterized before and after embedding into the composite. As expected, there was a blue shift in the reflection spectrum because of residual strain due to the embedding process. However, the quality of the signal did not degrade after embedding, both for 50 and 100 micron thick sensor foils. Finally, the sensitivity to strain of the embedded sensors was determined using a tensile test and found to be about 1 pm / microstrain.
Conference Presentation
© (2017) COPYRIGHT Society of Photo-Optical Instrumentation Engineers (SPIE). Downloading of the abstract is permitted for personal use only.
Jeroen Missinne, Nuria Teigell Benéitez, Gabriele Chiesura, Geert Luyckx, Joris Degrieck, and Geert Van Steenberge "Flexible thin polymer waveguide Bragg grating sensor foils for strain sensing", Proc. SPIE 10101, Organic Photonic Materials and Devices XIX, 101010X (16 February 2017);

Back to Top