Translator Disclaimer
20 February 2017 All plastic ultra-small size imaging lens unit fabrication and evaluation for endoscope
Author Affiliations +
Proceedings Volume 10110, Photonic Instrumentation Engineering IV; 1011005 (2017)
Event: SPIE OPTO, 2017, San Francisco, California, United States
There is demand for small-size lens units for endoscope and industrial applications. Polished glass lenses with a diameter of 1 - 2mm exist, however plastic lenses similar in size are not commonplace. For low-cost, light-weight, and mass production, plastic lens fabrication is extremely beneficial. Especially, in the medical field, there is strong demand for disposable lens unit for endoscopes which prevent contamination due to reuse of the lens. Therefore, high mass producible and low cost becomes increasingly important. This paper reports our findings on injection-molded ultra-small size plastic lens units with a diameter of 1.3mm and total thickness of 1.4mm. We performed optical design, injection molding, and lens unit assembly for injection moldable, high imaging performance ultra-small sized lens units. We prioritize a robust product design, considering injection molding properties and lens unit assembly, with feedback from molding simulations reflected into the optical design. A mold capable of high precision lens positioning is used to fabricate the lenses and decrease the variability of the assembly. The geometric dimensions of the resulting lenses, are measured and used in the optical simulation to validate the optical performance, and a high agreement is reported. The injection molding of the lens and the assembly of the lens unit is performed with high precision, and results in high optical performance.
© (2017) COPYRIGHT Society of Photo-Optical Instrumentation Engineers (SPIE). Downloading of the abstract is permitted for personal use only.
Kenta Ishii, Dai Okamoto, Makoto Ushio, Hidetoshi Tai, Atsuhiko Nishihara, Kimio Tokuda, Shinsuke Kawai, and Seiichiro Kitagawa "All plastic ultra-small size imaging lens unit fabrication and evaluation for endoscope", Proc. SPIE 10110, Photonic Instrumentation Engineering IV, 1011005 (20 February 2017);


Mobile platform optical design
Proceedings of SPIE (December 17 2014)
Thoughts On Teaching Geometrical Optics And Lens Design
Proceedings of SPIE (September 16 1980)
Design Of A Near Diffraction Limited Catadioptric Lens
Proceedings of SPIE (June 10 1987)

Back to Top