24 March 2017 Resist 3D aware mask solution with ILT for hotspot repair
Author Affiliations +
Abstract
New inverse methods such as model-based SRAF placement, model-based SRAF optimization, and full main + assist feature ILT are well known to have considerable benefits in finding flexible mask pattern solutions to improve process window and CD control. These methods have traditionally relied on compact models that are tuned to match resist measurements at a single z-height or slice. At this slice in the resist, some critical failure modes such as top loss and scumming are not detected. In this paper, we describe and present results for a methodology to extend ILT’s process window improvement capabilities, and to co-optimize mask patterns with awareness of the resist profile. These improvements are proven to reduce the risk of patterning failures at the bottom and top of critical resist features, which a typical mask correction process would not alleviate. Ideally, mask optimization would use a full rigorous TCAD resist model to guide the correction at multiple heights in the resist. However, TCAD models are significantly slower than compact models in simulations and ILT already has high computational requirements. Therefore, we have generated compact models which are fitted to the TCAD model resist profile data. We show the significant process window improvements obtained with this new resist 3D aware ILT methodology.
Conference Presentation
© (2017) COPYRIGHT Society of Photo-Optical Instrumentation Engineers (SPIE). Downloading of the abstract is permitted for personal use only.
Kosta Selinidis, Kosta Selinidis, Wolfgang Hoppe, Wolfgang Hoppe, Thomas Schmoeller, Thomas Schmoeller, Thuc Dam, Thuc Dam, Kevin Hooker, Kevin Hooker, Guangming Xiao, Guangming Xiao, } "Resist 3D aware mask solution with ILT for hotspot repair", Proc. SPIE 10147, Optical Microlithography XXX, 101470Q (24 March 2017); doi: 10.1117/12.2257962; https://doi.org/10.1117/12.2257962
PROCEEDINGS
10 PAGES + PRESENTATION

SHARE
RELATED CONTENT


Back to Top