19 October 2016 Design, fabrication, and testing of duralumin zoom mirror with variable thickness
Author Affiliations +
Proceedings Volume 10154, Advanced Optical Design and Manufacturing Technology and Astronomical Telescopes and Instrumentation; 1015409 (2016) https://doi.org/10.1117/12.2243992
Event: International Symposium on Optoelectronic Technology and Application 2016, 2016, Beijing, China
Abstract
Zoom mirror is a kind of active optical component that can change its curvature radius dynamically. Normally, zoom mirror is used to correct the defocus and spherical aberration caused by thermal lens effect to improve the beam quality of high power solid-state laser since that component was invented. Recently, the probable application of zoom mirror in realizing non-moving element optical zoom imaging in visible band has been paid much attention. With the help of optical leveraging effect, the slightly changed local optical power caused by curvature variation of zoom mirror could be amplified to generate a great alteration of system focal length without moving elements involved in, but in this application the shorter working wavelength and higher surface figure accuracy requirement make the design and fabrication of such a zoom mirror more difficult. Therefore, the key to realize non-moving element optical zoom imaging in visible band lies in zoom mirror which could provide a large enough saggitus variation while still maintaining a high enough surface figure. Although the annular force based actuation could deform a super-thin mirror having a constant thickness to generate curvature variation, it is quite difficult to maintain a high enough surface figure accuracy and this phenomenon becomes even worse when the diameter and the radius-thickness ratio become bigger. In this manuscript, by combing the pressurization based actuation with a variable thickness mirror design, the purpose of obtaining large saggitus variation and maintaining quite good surface figure accuracy at the same time could be achieved. A prototype zoom mirror with diameter of 120mm and central thickness of 8mm is designed, fabricated and tested. Experimental results demonstrate that the zoom mirror having an initial surface figure accuracy superior to 1/50λ could provide at least 21um saggitus variation and after finishing the curvature variation its surface figure accuracy could still be superior to 1/20λ, which proves that the effectiveness of the theoretical design.
© (2016) COPYRIGHT Society of Photo-Optical Instrumentation Engineers (SPIE). Downloading of the abstract is permitted for personal use only.
Zhao Hui, Zhao Hui, Xiaopeng Xie, Xiaopeng Xie, Liang Xu, Liang Xu, Jiaoteng Ding, Jiaoteng Ding, Le Shen, Le Shen, Meiying Liu, Meiying Liu, Jie Gong, Jie Gong, } "Design, fabrication, and testing of duralumin zoom mirror with variable thickness", Proc. SPIE 10154, Advanced Optical Design and Manufacturing Technology and Astronomical Telescopes and Instrumentation, 1015409 (19 October 2016); doi: 10.1117/12.2243992; https://doi.org/10.1117/12.2243992
PROCEEDINGS
8 PAGES


SHARE
Back to Top