26 June 2017 Out-of-squareness measurement on ultra-precision machine based on the error separation
Author Affiliations +
Abstract
Traditional methods of measuring out-of-squareness of ultra-precision motion stage have many limitations, especially the errors caused by inaccuracy of standard specimens, such as bare L-square and optical pentaprism. And generally, the accurate of out-of-squareness measurement is lower than the accurate of interior angles of standard specimens. Based on the error separation, this paper presents a novel method of out-of-squareness measurement with a polygon artifact. The angles bounded with the guideways and the edges of polygon artifact are measured, and the out-of-squareness distraction is achieved by the principle that the sum of internal the angles of a convex polygon artifact is (n-2)π. A out-of-squareness metrical experiment is carried out on the profilometer by using an optical square brick with the out-of-squareness of interior angles at about 1140.2 arcsec. The results show that the measurement accuracy of three out-of-squareness of the profilometer is not affected by the internal angles. The measurementwith the method can be applied to measure the machine error more accurate and calibrate the out-of-squareness of machine.
© (2017) COPYRIGHT Society of Photo-Optical Instrumentation Engineers (SPIE). Downloading of the abstract is permitted for personal use only.
Tao Lai, Tao Lai, Junfeng Liu, Junfeng Liu, Shanyong Chen, Shanyong Chen, Chaoliang Guan, Chaoliang Guan, Guipeng Tie, Guipeng Tie, Quan Liao, Quan Liao, } "Out-of-squareness measurement on ultra-precision machine based on the error separation", Proc. SPIE 10330, Modeling Aspects in Optical Metrology VI, 103301G (26 June 2017); doi: 10.1117/12.2270171; https://doi.org/10.1117/12.2270171
PROCEEDINGS
8 PAGES


SHARE
Back to Top