13 June 2017 Surface roughness measurement of additive manufactured samples using angular speckle correlation
Author Affiliations +
Proceedings Volume 10449, Fifth International Conference on Optical and Photonics Engineering; 104492W (2017) https://doi.org/10.1117/12.2270900
Event: Fifth International Conference on Optical and Photonics Engineering, 2017, Singapore, Singapore
Abstract
A speckle pattern is a direct fingerprint of surface height variation on the sample. In this paper, angular speckle correlation technique is applied to estimate surface roughness Ra of an additive manufactured sample with different surface roughness Ra values varying from 5μm to 20μm. Feasibility study is conducted to evaluate the correct incidence and the change in incidence angle for angular speckle correlation. Speckle correlation is computed from two speckle images that are recorded at two different incidence angles on the rough surface and surface roughness information is gleaned. Test results in terms of surface roughness measurement from standard calibration plate and additive layer manufactured samples are presented.
© (2017) COPYRIGHT Society of Photo-Optical Instrumentation Engineers (SPIE). Downloading of the abstract is permitted for personal use only.
Kapil Dev, Kapil Dev, Guru Prasad A. S., Guru Prasad A. S., Aswin H, Aswin H, Prabhathan P, Prabhathan P, Kelvin H. K. Chan, Kelvin H. K. Chan, Murukeshan V. Matham, Murukeshan V. Matham, } "Surface roughness measurement of additive manufactured samples using angular speckle correlation", Proc. SPIE 10449, Fifth International Conference on Optical and Photonics Engineering, 104492W (13 June 2017); doi: 10.1117/12.2270900; https://doi.org/10.1117/12.2270900
PROCEEDINGS
8 PAGES


SHARE
Back to Top