|
While the thus produced sensors have turned out to suit well for evanescent refractive index sensing in humidity-saturated environments like aqueous solutions, however, the additional deployment as an independent on-chip fluid temperature sensor is widely restricted due to the considerably temperature-dependent moisture uptake and swelling mechanisms of the epoxy materials, which are comparable to the well-known issues in polymethylmethacrylate. These severe mechanisms prevent the physical quantities temperature and relative humidity from being measured independently. Hence, the presented chip-design demands an extra sensor element solely responding to temperature variations. In this contribution, we therefore propose and evaluate three differing approaches to realize an enhanced optofluidic labon- a-chip-platform with integrated temperature sensor for a corrected RI measurement using multiple Bragg grating sensors. In the first approach, an EpoCore waveguide Bragg grating sensor is symmetrically sandwiched in between two humidity insensitive Topas 6017 sheets by solvent bonding. In the second method, an amount of COC is fully dissolved in cyclohexane solvent and the liquid copolymer is drop coated onto the sensor area in terms of a thin layer aiming for humidity desensitization. The third approach uses the COC substrate directly itself as temperature sensor material. Thereby, besides the epoxy waveguide grating, a separated further waveguide Bragg grating is laser-written into the Topas substrate material being inherently insensitive to humidity influences. |
ACCESS THE FULL ARTICLE
No SPIE Account? Create one
CITATIONS
Cited by 4 scholarly publications.
Bragg gratings
Waveguides
Epoxies
Microfluidics
Sensors
Humidity
Lab on a chip
