Translator Disclaimer
Paper
7 September 2018 Comparison between process simulation and deformation measured by defocused speckle photography
Author Affiliations +
Proceedings Volume 10834, Speckle 2018: VII International Conference on Speckle Metrology; 108341K (2018) https://doi.org/10.1117/12.2319384
Event: SPECKLE 2018: VII International Conference on Speckle Metrology, 2018, Janów Podlaski, Poland
Abstract
Defocused laser speckle photography is used as a tool to measure the heat responses in a titanium component during laser heating. The evolution of the response is compared with a set of preprocessed Finite Element Simulations of the corresponding process with the aim to verify the simulation model and to find the simulation settings that best resemble the experimental results. The titanium component consists of a 300 x 100 mm2 substrate of thickness 3.2 mm on which a 200 x 30 x 11 mm3 ridge is built up using the laser metal deposition by wire process. The component is heated on the top of the ridge by a 300 W laser for 10 s and the deformation of the subtrate is followed throughout the heating-cooling cycle. The simulated deformation gradient is shown to resemble the measured response, and the magnitude of the response indicates that about 70 % of the laser power transferres into heat in the metal.
© (2018) COPYRIGHT Society of Photo-Optical Instrumentation Engineers (SPIE). Downloading of the abstract is permitted for personal use only.
Joel Wahl, Per Gren, Per Bergström, Torbjörn Lindbäck, Malin Magnusson, Kristina Domeij, and Mikael Sjödahl "Comparison between process simulation and deformation measured by defocused speckle photography", Proc. SPIE 10834, Speckle 2018: VII International Conference on Speckle Metrology, 108341K (7 September 2018); https://doi.org/10.1117/12.2319384
PROCEEDINGS
8 PAGES


SHARE
Advertisement
Advertisement
Back to Top