Translator Disclaimer
4 March 2019 Dual mode photoacoustic and ultrasound imaging system based on a Fabry-Perot scanner (Conference Presentation)
Author Affiliations +
Abstract
Compared to piezoelectric based photoacoustic (PA) scanners, the planar Fabry-Perot (FP) scanner has several advantages. It can provide small element size with high sensitivity, a smooth broadband frequency response, and is transparent to excitation light. This enables the FP scanner to provide excellent high-resolution in vivo PA images of soft tissue to depths up to approximately 10 mm. However, unlike piezoelectric scanners, the FP scanner in its current form cannot provide a pulse-echo ultrasound (US) as well as a PA image, which is useful because of the additional tissue contrast it provides. To address this, a dual mode FP scanner-based system that, for the first time, can acquire co-registered 3D PA and US images has been developed. In order to provide an optical US generation capability, the FP ultrasound sensor was coated with a novel Gold-Nanoparticle-PDMS composite which was excited with nanosecond laser pulses to generate plane wave US pulses. By modifying the FP sensor in this way, it now acts as an US transmitter as well as a receiver. The coating is highly absorbing at the US generation wavelength (>95%) but transparent at the PA excitation wavelength, the latter to allow the system to also operate in PA imaging mode as before. The generated US pulses exhibited peak pressures in the MPa range, which is comparable to the output of conventional piezoelectric based medical US scanners. The pulses had a broad bandwidth (>40 MHz) and the emitted wavefront was planar to within λ/10 at 10 MHz. PA and pulse-echo US signals were mapped in turn by the FP scanner over centimetre scale areas with a step size of 100 μm and an element size of 64 μm. The -3dB bandwidth of the FP sensor was 30 MHz. Reconstruction methods using a k-space formulation recovered co-registered 3D PA and US images. The system’s lateral spatial resolution was evaluated by imaging a line target at depths up to 10 mm and ranged between 50 and 120 μm for both modes. Arbitrarily shaped 3D objects were imaged to demonstrate the volumetric US imaging capability of the scanner. Tissue mimicking phantoms, with impedance mismatches representative of soft tissues, and ex vivo tissue samples were imaged with the system as well as a conventional clinical US scanner for comparison. Finally, the system obtained promising high-resolution 3D dual mode PA-US images for a variety of phantoms with contrast based on both optical absorption and acoustic impedance. This novel all-optical system has the potential to add complementary morphological contrast to photoacoustic vascular images which could aid the clinical assessment of superficial tumours, lymph node disease and other conditions.
Conference Presentation
© (2019) COPYRIGHT Society of Photo-Optical Instrumentation Engineers (SPIE). Downloading of the abstract is permitted for personal use only.
Khoa Pham, Sacha Noimark, Nam Trung Huynh, Edward Zhang, Adrien Desjardins, Ben Cox, and Paul Beard "Dual mode photoacoustic and ultrasound imaging system based on a Fabry-Perot scanner (Conference Presentation)", Proc. SPIE 10878, Photons Plus Ultrasound: Imaging and Sensing 2019, 1087826 (4 March 2019); doi: 10.1117/12.2506922; https://doi.org/10.1117/12.2506922
PROCEEDINGS
PRESENTATION ONLY


SHARE
Advertisement
Advertisement
Back to Top