Paper
26 April 2019 Experimental investigation of a high-power 1018 nm monolithic tandem pump fiber source using 20/400 µm Yb-doped fiber
Author Affiliations +
Abstract
We have developed a high-power single mode monolithic tandem-pump fiber source operating at 1018 nm by employing a low core/cladding diameter ratio of 20/400 μm ytterbium-doped fiber. A record output power of 472 W is obtained, with a slope efficiency of 49.4% and near diffraction limited beam quality factor of M2 = 1.17. Careful numerical simulations were performed in order to determine the most suitable laser parameters such as reflectivity of output coupling fiber Bragg grating, length of active fiber and ytterbium ion concentration regarding a co-pumped oscillator setup. The signal output power behavior indicates that there are no limitations for further power scaling, except for insufficient pump power. This is apparently the highest recorded output signal power, efficiency and beam quality factor in monolithic 1018 nm fiber lasers using 20/400 μm ytterbiumdoped fibers. This structure can also be utilized as a high brightness pump fiber source of core-pumping ytterbium-doped highpower fiber amplifiers in a monolithic setup.
© (2019) COPYRIGHT Society of Photo-Optical Instrumentation Engineers (SPIE). Downloading of the abstract is permitted for personal use only.
M. Lafouti, H. Latifi, H. Fathi, S. Ebrahimzadeh, S. Sarikhani, H. Sarabi, V. Vatani, and S. H. Nabavi "Experimental investigation of a high-power 1018 nm monolithic tandem pump fiber source using 20/400 µm Yb-doped fiber", Proc. SPIE 11033, High-Power, High-Energy, and High-Intensity Laser Technology IV, 1103314 (26 April 2019); https://doi.org/10.1117/12.2520720
Lens.org Logo
CITATIONS
Cited by 1 scholarly publication.
Advertisement
Advertisement
RIGHTS & PERMISSIONS
Get copyright permission  Get copyright permission on Copyright Marketplace
KEYWORDS
Fiber lasers

Fiber Bragg gratings

Ytterbium

Fiber amplifiers

Oscillators

RELATED CONTENT


Back to Top