Paper
9 September 2019 Design of a multi-hole collimator for 3D gamma-ray imaging
Author Affiliations +
Abstract
Assessment of the distribution of radioactive contamination is an essential process for safe decommissioning. Gamma cameras are widely used to investigate the hot spots of radioactive materials. The 3D information of the radioactive contamination is required to reduce the occupational exposure and the radioactive waste. The purpose of this study is to design a multi-pinhole collimator for the 3D gamma ray imaging. The collimator was designed by Monte Carlo simulation and the performance was evaluated by lab test. The collimator consists of four cone-shaped pinholes, tungsten aperture, and lead septa. The acceptance angle and the source to detector distance were 40° and 15 cm, respectively. A number of 2D images were obtained by the linear motion of the gamma camera and the 3D images were reconstructed by filtered back-projection algorithm. As a result, the experimental results were within 2% of the expected values.
© (2019) COPYRIGHT Society of Photo-Optical Instrumentation Engineers (SPIE). Downloading of the abstract is permitted for personal use only.
Minju Lee, Eunbie Ko, Kilyoung Ko, Wooseub Kim, and Gyuseong Cho "Design of a multi-hole collimator for 3D gamma-ray imaging", Proc. SPIE 11114, Hard X-Ray, Gamma-Ray, and Neutron Detector Physics XXI, 111141X (9 September 2019); https://doi.org/10.1117/12.2528614
Advertisement
Advertisement
RIGHTS & PERMISSIONS
Get copyright permission  Get copyright permission on Copyright Marketplace
KEYWORDS
Collimators

Cameras

Sensors

3D image processing

Gamma radiation

Reconstruction algorithms

Monte Carlo methods

RELATED CONTENT


Back to Top