Translator Disclaimer
Paper
26 September 2019 OPC model building for EUV lithography
Author Affiliations +
Abstract
After an initial introduction into logic fabrication, EUV lithography is finally moving into memory fabrication, and now memory companies must untangle the complex physics required to create an aerial image with this next generation technology. The optical proximity correction (OPC) model must understand and compensate for new EUV phenomena, such as non-telecentric illumination induced shadowing, across-slit variation, optical flare, and reticle black border effects. This paper compares the EUV OPC Modeling flow with the DUV modeling flow and discusses the new challenges EUV presents to OPC Model building for high-volume manufacturing.
© (2019) COPYRIGHT Society of Photo-Optical Instrumentation Engineers (SPIE). Downloading of the abstract is permitted for personal use only.
Benjamin C. P. Ho, Jonathan Doebler, and Ardavan Niroomand "OPC model building for EUV lithography", Proc. SPIE 11147, International Conference on Extreme Ultraviolet Lithography 2019, 1114714 (26 September 2019); https://doi.org/10.1117/12.2531430
PROCEEDINGS
8 PAGES


SHARE
Advertisement
Advertisement
RELATED CONTENT

EUV OPC modeling and correction requirements
Proceedings of SPIE (March 18 2014)
Evaluation of methods to improve EUV OPC model accuracy
Proceedings of SPIE (April 01 2013)
Model calibration and validation for pre-production EUVL
Proceedings of SPIE (March 23 2012)
Accurate models for EUV lithography
Proceedings of SPIE (September 23 2009)
Full chip correction of EUV design
Proceedings of SPIE (March 20 2010)

Back to Top