Development of blue diode laser for additive manufacturing

R. Higashino; Y. Sato; S. Masuno; T. Shobu; Y. Funada; N. Abe; M. Tsukamoto

doi:10.1117/12.2543119

2 March 2020 Development of blue diode laser for additive manufacturing

R. Higashino, Y. Sato, S. Masuno, T. Shobu, Y. Funada, N. Abe, M. Tsukamoto

Author Affiliations +

Proceedings Volume 11271, Laser 3D Manufacturing VII; 1127114 (2020) https://doi.org/10.1117/12.2543119
Event: SPIE LASE, 2020, San Francisco, California, United States

Abstract

We developed several blue diode lasers and applied laser metal deposition one of the additive manufacturing technologies. This system has two laser modules, a focusing head, a powder feeder and a XYZ stage. Fiber couple direct diode laser module was guided to focusing head by optical fiber, which core diameter is 400 μm. In case pure copper layer formation with blue diode laser, the laser output power is 80 W, a scanning speed is 10 mm/s. A powder feed rate was varied from 14 to 80 mg/s. The stage was moved to the X direction. And In case pure copper rod formation with blue diode laser, the laser output power is 80 W and a scanning speed is 4 mm/s. A powder feed rate was varied from 14 to 80 mg/s. The stage was moved to the Z direction. Layer thickness was linearly increased to 40ms in all powder feed rate and the layer formation rate was gradually decreased over 40ms. An average slope Δspeed = 4 mm/s at 40 ms is obtained. From this, it is considered that pure copper rod can be formed by pulling upward at 4 mm/s. Based on the results obtained from copper layer, pure copper was stacked upward (direction Z) to form a pure copper wire. The result as expected was obtained by raising the speed at 4 mm/s. And since a thin molten pool was formed only in a limited area, it was observed that the molten pool was piled up without melting. It was confirmed that the flying powder adhered without melting. And thereafter, it was melted to form a rod. It was confirmed that there were no pore in pure copper rod.

Citation Download Citation

R. Higashino, Y. Sato, S. Masuno, T. Shobu, Y. Funada, N. Abe, and M. Tsukamoto "Development of blue diode laser for additive manufacturing", Proc. SPIE 11271, Laser 3D Manufacturing VII, 1127114 (2 March 2020); https://doi.org/10.1117/12.2543119

ACCESS THE FULL ARTICLE

INSTITUTIONAL
Select your institution to access the SPIE Digital Library.

SELECT YOUR INSTITUTION

PERSONAL
Sign in with your SPIE account to access your personal subscriptions or to use specific features such as save to my library, sign up for alerts, save searches, etc.

PERSONAL SIGN IN

No SPIE Account? Create one

;

PURCHASE THIS CONTENT

SUBSCRIBE TO DIGITAL LIBRARY

50 downloads per 1-year subscription

Members: $195

Non-members: $335 ADD TO CART

25 downloads per 1 - year subscription

Members: $145

Non-members: $250 ADD TO CART

PURCHASE SINGLE ARTICLE