Field Determination Of Ground Water Contamination Using Laser Fluorescence And Fiber Optics

Wayne Chudyk; Kenneth Pohlig; Lisa Wolf; Rita Fordiani

doi:10.1117/12.963181

13 February 1990 Field Determination Of Ground Water Contamination Using Laser Fluorescence And Fiber Optics

Wayne Chudyk, Kenneth Pohlig, Lisa Wolf, Rita Fordiani

Author Affiliations +

Proceedings Volume 1172, Chemical, Biochemical, and Environmental Fiber Sensors; (1990) https://doi.org/10.1117/12.963181
Event: OE/FIBERS '89, 1989, Boston, United States

Abstract

Experience at over sixteen sites containing over one hundred wells has shown the feasibility of using fiber optic systems for in situ measurement of aromatic ground water contaminants. Aromatic solvents, as well as the benzene, ethylbenzene, toluene, and xylenes (BTEX) fraction of gasoline, have been detected using a prototype field instrument. Well depths have varied from 5 m to 30 m, and limits of detection at 10 m have been in the ppb range. We are routinely using two separate clear tefzel-coated optical fibers bound in a black teflon tubing for in situ sensing of aromatic organic ground water contaminants via laser-induced fluorescence. One fiber, the excitation fiber, carries the 266 nm, 15 nanosecond, laser pulse down to the sensor. The other fiber, used for detection, carries collected fluorescence plus scattered laser light back up to the surface to the detector. Optical crosstalk has been observed to occur along the entire length of the sensor tubing. This may be due to fiber fluorescence. The fiber crosstalk is eliminated by use of a 320 nm cutoff filter in the detector optics. Black tefzel-coated fibers are also commercially available which could eliminate this potential problem. Evaluation of fluorescence emission versus concentration using serial dilution of standards shows that fluorescence lifetimes are important when evaluating different concentrations as well as in evaluation of mixtures. Minimization of signal-to-noise ratios in the detector electronics involves tuning the gate width used in measuring the fluorescent pulse, in order to include the full fluorescent signal returning from the contaminants. Field tests of the modular prototype instrument have been successful in their demonstration of the feasibility of this new technology. Results at a variety of types of sites are presented, showing the flexibility of the modular approach used in the design and operation of this new instrument.

Citation Download Citation

Wayne Chudyk, Kenneth Pohlig, Lisa Wolf, and Rita Fordiani "Field Determination Of Ground Water Contamination Using Laser Fluorescence And Fiber Optics", Proc. SPIE 1172, Chemical, Biochemical, and Environmental Fiber Sensors, (13 February 1990); https://doi.org/10.1117/12.963181

ACCESS THE FULL ARTICLE

INSTITUTIONAL
Select your institution to access the SPIE Digital Library.

SELECT YOUR INSTITUTION

PERSONAL
Sign in with your SPIE account to access your personal subscriptions or to use specific features such as save to my library, sign up for alerts, save searches, etc.

PERSONAL SIGN IN

No SPIE Account? Create one

;

PURCHASE THIS CONTENT

SUBSCRIBE TO DIGITAL LIBRARY

50 downloads per 1-year subscription

Members: $195

Non-members: $335 ADD TO CART

25 downloads per 1 - year subscription

Members: $145

Non-members: $250 ADD TO CART

PURCHASE SINGLE ARTICLE