1 June 1990 Effect of CO2 laser on dentinal bonding
Author Affiliations +
Abstract
Previous studies have suggested that pulsed laser energy can enhance the bond strengths to dentin of certain dentinal bonding agents. The objective of this study was to investigate and compare the shear bond strength of Scotchbond 2 dentin adhesive (3M) to continuous-wave carbon dioxide laser-irradiated vs. unirradiated dentin. Forty extracted molars were mounted in an acrylic base with the crowns exposed. Dentin surfaces of diameters greater than 5mm were cut perpendicular to the base of the acrylic, treated for 60 seconds with dentin primer, air-dried, and randomly distributed into two groups. The experimental was exposed to CW-C02 laser irradiated at 13.5W for 0.10 sec., and a spot diameter of 5mm. The other group served as the nonirradiated control. A brass ring of 4mm internal diameter was placed on each surface and filled to a depth of 1.0mm with SB 2 and cured. P-50 (3M) composite was condensed and cured into the rings in three one-millimeter increments and then shear strength tested on an Instron machine using a crosshead speed of 0.005 in/mm. The mean shear strength and strain values for the irradiated and control group were 2. 193 MPa, 3.87 x i03, 1 .023 MPa, and 3.3 1 x iO, respectively. Pillai's Criterion and the Univariate F-test indicated that the mean shear strengths were significantly different (p=O.Ol49). These results suggest that dentin bond shear strengths may be enhanced by CWCO2 laser pretreatment.
© (1990) COPYRIGHT Society of Photo-Optical Instrumentation Engineers (SPIE). Downloading of the abstract is permitted for personal use only.
Douglas N. Dederich, Douglas N. Dederich, Kenneth W. Hinkelman, Kenneth W. Hinkelman, Andrew Albert, Andrew Albert, John Tulip, John Tulip, } "Effect of CO2 laser on dentinal bonding", Proc. SPIE 1200, Laser Surgery: Advanced Characterization, Therapeutics, and Systems II, (1 June 1990); doi: 10.1117/12.17488; https://doi.org/10.1117/12.17488
PROCEEDINGS
5 PAGES


SHARE
RELATED CONTENT

Laser ablation of enamel and composite using 355 nm laser...
Proceedings of SPIE (February 14 2006)
Developing consistency in enamel etching by CO2 laser
Proceedings of SPIE (September 06 1994)
Effect of Nd:YAG laser on dentinal bond strength
Proceedings of SPIE (April 30 1991)
Bond strength of composites on Er YAG and Er,Cr YSGG...
Proceedings of SPIE (February 03 1999)
Effect of a new carbon dioxide laser and fluoride on...
Proceedings of SPIE (June 02 2002)

Back to Top