Translator Disclaimer
1 October 1990 Scatter or finish specifications for beryllium mirrors?
Author Affiliations +
Scatter from beryllium mirrors often seems to be higher than expected based on mirror surface foughness data. The paper verifies the effects and shows that in addition to surface topography scatter is caused by mirror defects that are non-topographic in nature (subsurface flaws, optical contant variations across grain boundaries, etc.). This effect is more severe in them id IR than the visible because non-topographical scatter tends to scale as inverse wavelengths for several materials is presented and analyzed. Beryllium is found to be especially prone to these problems. The conclusion is reached, that a profile (or roughness) requirement is not sufficent speciefication to achieve low scatter space mirrors.
© (1990) COPYRIGHT Society of Photo-Optical Instrumentation Engineers (SPIE). Downloading of the abstract is permitted for personal use only.
John C. Stover "Scatter or finish specifications for beryllium mirrors?", Proc. SPIE 1307, Electro-Optical Materials for Switches, Coatings, Sensor Optics, and Detectors, (1 October 1990);


Pulsed electron-beam testing of optical surfaces
Proceedings of SPIE (December 31 1990)
No such thing as sigma flowdown and measurement of...
Proceedings of SPIE (September 06 2006)
Pathfinder experiment on particulates after jet spray
Proceedings of SPIE (December 17 1992)
Measurement and analysis of scatter from rough surfaces
Proceedings of SPIE (October 06 1994)
Visible scatter measurements of various materials
Proceedings of SPIE (November 30 1990)
Design problems of a calibrated BRDF sensor with respect to...
Proceedings of SPIE (September 25 2000)

Back to Top