1 September 1990 Nickel silicide Schottky-barrier detectors for short-wavelength infrared applications
Author Affiliations +
Abstract
The utilization of both cobalt and nickel silicides as Schottky detectors is presented with both theoretical and experimental supporting data. The uses considered are limited to those with a typical cut-off frequency of more than 2.2 microns, such as earth observation and satellite imaging spectroscopy. The theoretical calculations of key parameters of Schottky-barrier detectors are discussed, including quantum efficiency, the dark current, and the noise. Experimentally, Co and Ni layers were tested on silicon wafers at a variety of temperatures and layer thicknesses. Average values for the barrier height, activation analysis, and quantum efficiency are given and compared. The dark current for both Ni and Co is shown to be negligible below 140-160 K, and Ni quantum efficiencies are higher than those for Co, as is the measured barrier height. The theoretical and technological requirements are met by both cobalt and nickel silicides. The characteristics tested show that Ni and Co silicides are appropriate for realizing large focal planes with high dark current and responsivity homogeneity.
© (1990) COPYRIGHT Society of Photo-Optical Instrumentation Engineers (SPIE). Downloading of the abstract is permitted for personal use only.
Jerzy M. Kurianski, Jerzy M. Kurianski, J. Van Damme, J. Van Damme, Jan P. Vermeiren, Jan P. Vermeiren, Karen Maex, Karen Maex, Cor L. Claeys, Cor L. Claeys, } "Nickel silicide Schottky-barrier detectors for short-wavelength infrared applications", Proc. SPIE 1308, Infrared Detectors and Focal Plane Arrays, (1 September 1990); doi: 10.1117/12.21714; https://doi.org/10.1117/12.21714
PROCEEDINGS
9 PAGES


SHARE
Back to Top