1 September 1991 PC-based determination of 3-D deformation using holographic interferometry
Author Affiliations +
Abstract
It is shown that a three-dimensional analysis of the deformation of a planar surface can be performed utilizing holographic interferometry and by simple and relatively inexpensive means. In order to obtain the in-plane deformations in addition to the out-of-plane deformation, a single interferogram resulting from the double exposure of two states with different mechanical loads has been viewed from at least three noncoplanar directions. The image distortion due to the perspective projection has been taken into account and a simple algorithm found to decompose the three deformations along the orthogonal coordinate axes. For the electronic recording, the fringe interpolation, and the demodulation of the two (pi) ambiguity, commercially available software has been used. This system has been applied to the investigation of a model drill tip under different compressive loads.
© (1991) COPYRIGHT Society of Photo-Optical Instrumentation Engineers (SPIE). Downloading of the abstract is permitted for personal use only.
Hanspeter Schad, Edwin Schweizer, Heibert Jodlbauer, "PC-based determination of 3-D deformation using holographic interferometry", Proc. SPIE 1507, Holographic Optics III: Principles and Applications, (1 September 1991); doi: 10.1117/12.47065; https://doi.org/10.1117/12.47065
PROCEEDINGS
4 PAGES


SHARE
Back to Top