1 December 1991 Improved plastic molding technology for ophthalmic lens and contact lens
Author Affiliations +
Abstract
A patented new injection-molding technology, which already has been commercially licensed nonexclusively to leading Rx polycarbonate lensmakers and is now under development with leading contact lensmakers, gives very high moldpacking pressures (needed for maximum microsurface replication) without high birefringence (minimized by reducing constrictiveness during fill), even with high viscosity optical thermoplastic polymers.
© (1991) COPYRIGHT Society of Photo-Optical Instrumentation Engineers (SPIE). Downloading of the abstract is permitted for personal use only.
George J. Galic, George J. Galic, Steven Maus, Steven Maus, } "Improved plastic molding technology for ophthalmic lens and contact lens", Proc. SPIE 1529, Ophthalmic Lens Design and Fabrication, (1 December 1991); doi: 10.1117/12.50476; https://doi.org/10.1117/12.50476
PROCEEDINGS
9 PAGES


SHARE
Back to Top