Paper
1 December 1991 Integrated optics bus access module for intramachine communication
Author Affiliations +
Abstract
The feasibility of a passive bidirectional fiber optic bus and the packaging considerations of a bus access module have been studied. The bus uses 110/125 micrometers HCS fiber and passive integrated optic couplers for bus access. The access couplers are asymmetric and were fabricated using a Ag-Na ion exchange process. The asymmetry of the coupler was 5 dB, the launch loss to the bus was 6 dB and the tap-off loss to the node was 11 dB. With the integrated optics coupler it is possible to connect 6 nodes to the bidirectional bus. It is also possible to realize a simple, easy-to-use, and reliable bus access module for intramachine communication. The integrated optics coupler, a LED chip, and a PIN-diode chip and transceiver electronics are packaged in an electrical connector with a two-fiber optical cable pigtail. Active and passive components are butt coupled to the coupler. The 0.5 dB alignment tolerances for the fiber pigtails, the LED, and the PIN-diode chips are +/- 5 micrometers .
© (1991) COPYRIGHT Society of Photo-Optical Instrumentation Engineers (SPIE). Downloading of the abstract is permitted for personal use only.
Pentti Karioja, Simo K. T. Tammela, and Tapio Hannula "Integrated optics bus access module for intramachine communication", Proc. SPIE 1533, Optomechanics and Dimensional Stability, (1 December 1991); https://doi.org/10.1117/12.48849
Advertisement
Advertisement
RIGHTS & PERMISSIONS
Get copyright permission  Get copyright permission on Copyright Marketplace
KEYWORDS
Waveguides

Light emitting diodes

Adhesives

Integrated optics

Tolerancing

Electronics

Optomechanical design

Back to Top