4 December 2017 A high gain quasi-monolithic horn antenna
Author Affiliations +
Proceedings Volume 1576, 16th International Conference on Infrared and Millimeter Waves; 157673 (2017) https://doi.org/10.1117/12.2297968
Event: 16th International Conference on Infrared and Millimeter Waves, 1991, Lausanne, Switzerland
Abstract
Integrated horn antennas have been proved to be very well suited for millimeter-wave applications. They consist of a strip-dipole antenna suspended on a thin dielectric membrane inside a pyramidal cavity etched in silicon [1]. The antennas are free from surface-wave losses and fully monolithic. However their large flare-angle of 70°, which is inherent in the anisotropic etching of < 100 > silicon, limits their gain below 13dB and their 10dB beamwidth above 90°. In this paper a quasi-monolithic dual-mode horn is introduced which increases the gain to 20dB with a high circular symmetry and a high 97% Gaussian coupling (fig. 1). As shown in figure 1, a machined section has been superimposed on a standard integrated horn antenna to increase the radiating aperture to 3.56λ. The junction of the integrated section and the machined section acts as a mode converter which mainly converts some of the incident TE10 mode to the TE12, TM12 modes. The modes are properly phased on the radiating aperture by selecting the flare-angle and the length of the machined section. This results in highly symmetric, low cross-polarization far-field patterns.
© (2017) COPYRIGHT Society of Photo-Optical Instrumentation Engineers (SPIE). Downloading of the abstract is permitted for personal use only.
George V. Eleftheriades, "A high gain quasi-monolithic horn antenna", Proc. SPIE 1576, 16th International Conference on Infrared and Millimeter Waves, 157673 (4 December 2017); doi: 10.1117/12.2297968; https://doi.org/10.1117/12.2297968
PROCEEDINGS
2 PAGES


SHARE
RELATED CONTENT


Back to Top