18 January 1993 In-process drilling-states monitoring in machining centre by time series analysis
Author Affiliations +
Proceedings Volume 1713, International Conference on Manufacturing Automation; (1993) https://doi.org/10.1117/12.138480
Event: International Conference on Manufacturing Automation, 1992, Hong Kong, Hong Kong
Abstract
Monitoring of the cutting process is one of the most crucial and difficult problems in unmanned machining technology. In this paper, the effects to the thrust and the torque in drilling by some abnormal cutting states have been investigated. Experiments show that the dynamic components of the thrust and the torque provide useful information for identifying different tool failures. Reasonable explanations have been given for the phenomena from physical mechanisms. A mathematical model for the dynamic cutting process was proposed and some problems about the estimation of the time series AR(n) model were also discussed. After having compared several defined monitoring parameters, a new inprocess signal processing method, `adaptive variance-residual recursive algorithm,' based on least squares theory has been suggested with which signal signatures of cutting states can be extracted effectively. It bears the advantages of rapid response, less amount of calculation, and easy to set deterministic thresholds. The in-process monitoring system developed shows a bright prospect in practical application.
© (1993) COPYRIGHT Society of Photo-Optical Instrumentation Engineers (SPIE). Downloading of the abstract is permitted for personal use only.
Gengsheng S. Li, Gengsheng S. Li, W. S. Lau, W. S. Lau, Y. Z. Zhang, Y. Z. Zhang, C. Y. Jiang, C. Y. Jiang, } "In-process drilling-states monitoring in machining centre by time series analysis", Proc. SPIE 1713, International Conference on Manufacturing Automation, (18 January 1993); doi: 10.1117/12.138480; https://doi.org/10.1117/12.138480
PROCEEDINGS
12 PAGES


SHARE
Back to Top