Paper
25 February 1993 First photon-shutter development for APS insertion device beamline front ends
Deming Shu, H. L. Thomas Nian, Zhibi Wang, Jeffrey T. Collins, David G. Ryding, Tuncer M. Kuzay
Author Affiliations +
Abstract
One of the most critical components on the Advanced Photon Source (APS) insertion device (ID) beamline front ends is the first photon shutter. It operates in two modes to fully intercept the high total power and high-heat-flux ID photon beam in seconds (normal mode) or in less than 100 ms (emergency fast mode). It is designed to operate in ultra high vacuum (UHV). The design incorporates a multi-channel rectangular bar, bent in a `hockey stick' configuration, with two-point suspension. The flanged end is an articulated bellows with rolling hinges. The actuation end is a spring-assisted, pneumatic fail-safe flexural pivot type. The coolant (water) channels incorporate brazed copper foam to enhance the heat transfer, a tube technology particular to the APS. The design development, and material aspects, as well as the extensive thermal and vibrational analyses in support of the design, are presented in this paper.
© (1993) COPYRIGHT Society of Photo-Optical Instrumentation Engineers (SPIE). Downloading of the abstract is permitted for personal use only.
Deming Shu, H. L. Thomas Nian, Zhibi Wang, Jeffrey T. Collins, David G. Ryding, and Tuncer M. Kuzay "First photon-shutter development for APS insertion device beamline front ends", Proc. SPIE 1739, High Heat Flux Engineering, (25 February 1993); https://doi.org/10.1117/12.140525
Lens.org Logo
CITATIONS
Cited by 6 scholarly publications.
Advertisement
Advertisement
RIGHTS & PERMISSIONS
Get copyright permission  Get copyright permission on Copyright Marketplace
KEYWORDS
Camera shutters

Copper

Heat flux

Analytical research

Safety

Foam

Actuators

Back to Top