21 January 1993 SIRTF thermal design modifications to increase lifetime
Author Affiliations +
Abstract
An effort was made to increase the predicted lifetime of the SIRTF dewar by lowering the exterior shell temperature, increasing the radiated energy from the vapor cooled shields and reconfiguring the vapor cooled shields. The lifetime increases can be used to increase the scientific return from the mission and as a trade-off against mass and cost. This paper describes the configurations studied, the steady state thermal model used, the analytical methods and the results of the analysis. Much of the heat input to the outside dewar shell is radiative heat transfer from the solar panel. To lower the shell temperature, radiative cooled shields were placed between the solar panel and the dewar shell and between the bus and the dewar shell. Analysis showed that placing a radiator on the outer vapor cooled shield had a significant effect on lifetime. Lengthening the distance between the outer shell and the point where the vapor cooled shields are attached to the support straps also improved lifetime.
© (1993) COPYRIGHT Society of Photo-Optical Instrumentation Engineers (SPIE). Downloading of the abstract is permitted for personal use only.
Stanley Walter Petrick, "SIRTF thermal design modifications to increase lifetime", Proc. SPIE 1765, Cryogenic Optical Systems and Instruments V, (21 January 1993); doi: 10.1117/12.140890; https://doi.org/10.1117/12.140890
PROCEEDINGS
8 PAGES


SHARE
RELATED CONTENT

Thermal modeling for an optical refrigerator
Proceedings of SPIE (March 10 2015)
Operating SIRTF for maximum lifetime
Proceedings of SPIE (March 05 2003)
Concepts For On-Orbit Servicing Of SIRTF
Proceedings of SPIE (July 18 1986)
Computer-Aided Infrared Sensor Thermal Design
Proceedings of SPIE (June 30 1982)

Back to Top