Paper
27 September 1993 Failure analysis of adhesively bonded composite joint: an elasto-plastic approach
S. C. Pradhan, N. N. Kishore, N. G. R. Iyengar
Author Affiliations +
Abstract
Joints are important load transferring members in large assembled structures. In joining similar and dissimilar materials, the use of adhesives offers many advantages when compared to other conventional methods. Most commonly used adhesives are the polymers, which exhibit nonlinear behavior. Finite element analysis with paired nodes along the crack path is employed to predict the crack initiation and growth leading to failure. The bond strength is predicted by investigating the possibility of propagation of a crack at the interface of adherend and adhesive. Paired nodes are opened in a sequence, modelling the crack growth. The adhesive is treated to be elasto-plastic for its response. Effect of the parameters such as, stacking sequences in composite adherend, crack growth locations, bond length, bond thicknesses and adhesive stiffnesses on the failure load is studied. The growth of plastic zone as the crack propagates is also examined. On the basis of this study optimal geometrical and material parameters are suggested. The elasto-plastic analysis predicts higher failure loads as compared to linear elastic analysis. The computed bond strength assuming elastic behavior for the adhesive shows satisfactory comparison with experimental results.
© (1993) COPYRIGHT Society of Photo-Optical Instrumentation Engineers (SPIE). Downloading of the abstract is permitted for personal use only.
S. C. Pradhan, N. N. Kishore, and N. G. R. Iyengar "Failure analysis of adhesively bonded composite joint: an elasto-plastic approach", Proc. SPIE 1999, Adhesives Engineering, (27 September 1993); https://doi.org/10.1117/12.158611
Advertisement
Advertisement
RIGHTS & PERMISSIONS
Get copyright permission  Get copyright permission on Copyright Marketplace
KEYWORDS
Adhesives

Failure analysis

Composites

Finite element methods

Interfaces

Analytical research

Modeling

Back to Top