22 September 1993 In-process tool wear and failure measurement
Author Affiliations +
Proceedings Volume 2101, Measurement Technology and Intelligent Instruments; (1993) https://doi.org/10.1117/12.156263
Event: Measurement Technology and Intelligent Instruments, 1993, Wuhan, China
With the progressive automation of the machining process it is becoming increasingly necessary to have a reliable tool wear and failure monitor. This paper provides the results of a comprehensive investigation into the efficacy of using the dynamic tangential component of the cutting force to predict the imniinence of tool failure. Experiments were carried out using different workpiece and tool materials tool geometries and machining conditions. It was found that it is possible to set threshold values to give indications of when the tool is deemed to have failed.
© (1993) COPYRIGHT Society of Photo-Optical Instrumentation Engineers (SPIE). Downloading of the abstract is permitted for personal use only.
Lye Huat Lee, Lye Huat Lee, Swee Hin Teoh, Swee Hin Teoh, X. D. Liu, X. D. Liu, } "In-process tool wear and failure measurement", Proc. SPIE 2101, Measurement Technology and Intelligent Instruments, (22 September 1993); doi: 10.1117/12.156263; https://doi.org/10.1117/12.156263


A novel sliding window algorithm for 2D discrete...
Proceedings of SPIE (December 13 2015)
A Microprocessor-Based Optical/Digital Processor
Proceedings of SPIE (November 21 1977)
The Use Of Headspace GC FT IR For The Monitoring...
Proceedings of SPIE (November 30 1989)
Designing avionics for terrestrial neutron environments
Proceedings of SPIE (August 31 2004)

Back to Top