Translator Disclaimer
22 September 1993 Laser measuring scanners and their accuracy limits
Author Affiliations +
Proceedings Volume 2101, Measurement Technology and Intelligent Instruments; (1993) https://doi.org/10.1117/12.156282
Event: Measurement Technology and Intelligent Instruments, 1993, Wuhan, China
Abstract
Scanning methods have gained the greater importance for some years now due to a short measuring time and wide range of application in flexible manufacturing processes. This paper is a summing up of the autho?s creative scientific work in the field of measuring scanners. The research conducted allowed to elaborate the optimal configurations of measuring systems based on the scanning method. An important part of the work was the analysis of a measuring scanner - as a transducer of an angle rotation into the linear displacement which resulted in obtaining its much higher accuracy and finally in working out a measuring scanner eliminating the use of an additional reference standard. The completion of the work is an attempt to determine an attainable accuracy limit of scanning measurement of both length and angle. Using a high stability deflector and a corrected scanning lens one can obtain the angle determination over 30 (or 2 mm) to an accuracy 0 (or 0 tm) when the measuring rate is 1000 Hz or the range d60 (4 mm) with accuracy 0 " (0 jim) and measurement frequency 6 Hz.
© (1993) COPYRIGHT Society of Photo-Optical Instrumentation Engineers (SPIE). Downloading of the abstract is permitted for personal use only.
Ryszard Jablonski "Laser measuring scanners and their accuracy limits", Proc. SPIE 2101, Measurement Technology and Intelligent Instruments, (22 September 1993); https://doi.org/10.1117/12.156282
PROCEEDINGS
9 PAGES


SHARE
Advertisement
Advertisement
RELATED CONTENT

Design of a compact 3D laser scanner
Proceedings of SPIE (August 26 1999)
Balancing of a polygonal scanner for HDTV applications
Proceedings of SPIE (July 01 1999)
Low Wobble Resonant Scanners
Proceedings of SPIE (September 19 1982)

Back to Top