22 September 1993 On-line cylindricity-measurement and error compensating control in an ultra-precision lathe
Author Affiliations +
Proceedings Volume 2101, Measurement Technology and Intelligent Instruments; (1993) https://doi.org/10.1117/12.156339
Event: Measurement Technology and Intelligent Instruments, 1993, Wuhan, China
Abstract
An on-line cylindricity measuring and compensating system is currently developped in our lab at Changsha Institute of Technology. Firstly the modeling about the error and on-line measuring is introduced in this paper. Based on 3-point method EST (Error Separating Technique) the method has been improved and used to separate the workpiece form error from error caused by inaccurate motion of machine tool. In order to overcome complrx modeling problem of the pizoelectrical actuator a new cotrol method P-integrator learning control i uHed to increase the accuracy of tracking compensating control. The experiment shows that the accuracy of cylindricity measurement is within 0 05 rn tlkL compensated cylindricity within 0. 2 m/6Omm which is improved more than 85.
© (1993) COPYRIGHT Society of Photo-Optical Instrumentation Engineers (SPIE). Downloading of the abstract is permitted for personal use only.
Shengyi Li, Ming-Nuan Qin, C. James Li, "On-line cylindricity-measurement and error compensating control in an ultra-precision lathe", Proc. SPIE 2101, Measurement Technology and Intelligent Instruments, (22 September 1993); doi: 10.1117/12.156339; https://doi.org/10.1117/12.156339
PROCEEDINGS
4 PAGES


SHARE
Back to Top