Paper
1 May 1994 Active noise control using piezoelectric actuator for a machine
Author Affiliations +
Abstract
The use of active noise control applied to an industrial machine is investigated. The control system consists of an analog controller, an optical synchronous sensor, an error microphone, and an actuator. The signal from the optical sensor, which is synchronized with the impacts, is compensated by the controller and then sent to the actuator. The controller automatically adjusts itself according to the error signal to get maximum noise reduction. Instead of the more traditional loudspeakers used in noise control systems, a piezoelectric actuator is developed to work in a harsh industrial environment. The actuator is basically a bending mode vibrator made of aluminum and PZT (lead zirconate titanate) plates and is able to work in the frequency range of interest. A computer program based on the finite element approach was developed to aid the design of the actuator. The predicted output and the measured one agree very well. The system is tested in a laboratory setup by replaying the noise recorded from the machine. A reduction of 10 dB(A) is achieved.
© (1994) COPYRIGHT Society of Photo-Optical Instrumentation Engineers (SPIE). Downloading of the abstract is permitted for personal use only.
Xiao-Qi Bao, Zoubeida Ounaies, Vijay K. Varadan, and Vasundara V. Varadan "Active noise control using piezoelectric actuator for a machine", Proc. SPIE 2189, Smart Structures and Materials 1994: Smart Materials, (1 May 1994); https://doi.org/10.1117/12.174058
Advertisement
Advertisement
RIGHTS & PERMISSIONS
Get copyright permission  Get copyright permission on Copyright Marketplace
KEYWORDS
Actuators

Sensors

Ferroelectric materials

Control systems

Aluminum

Analog electronics

Optical sensors

Back to Top