Translator Disclaimer
17 October 1994 Performance prediction and experimental assessment of advanced thermal imagers
Author Affiliations +
For the assessment of undersampled systems, it is proposed to replace the MRTD with the MTDP (minimum temperature difference perceived). As the MRTD, the MTDP is based on the perception of the standard four bar test pattern, but it is not required that all four bars be resolved in the image. The MTDP refers to a specific phase position which is called the optimum phase, and is derived from the average modulation in the reproduced image. Reproducible measurements can be obtained with this technique up to spatial frequencies of about 85% of the sampling frequency. The MTDP can be predicted with the same analytical approach known for the MRTD by replacing the system MTF with the average modulation at optimum phase. Measured MTDP data is presented for several undersampled systems and compared to analytical predictions.
© (1994) COPYRIGHT Society of Photo-Optical Instrumentation Engineers (SPIE). Downloading of the abstract is permitted for personal use only.
Wolfgang Wittenstein "Performance prediction and experimental assessment of advanced thermal imagers", Proc. SPIE 2269, Infrared Technology XX, (17 October 1994);


Edge response revisited
Proceedings of SPIE (April 14 2008)
Dynamic MRTD simulation
Proceedings of SPIE (July 16 2000)
Simulation study on fixed pattern noise and MRTD
Proceedings of SPIE (September 07 1995)
Objective MRTD measurement: an update
Proceedings of SPIE (September 30 1990)

Back to Top