Translator Disclaimer
29 September 1995 Time-division-multiplexed laser Doppler anemometry using pulsed laser diodes and optical fibers
Author Affiliations +
A time division multiplexed laser Doppler anemometer is reported, using a single high frequency pulsed laser diode as a source. Time division multiplexing requires a single detector channel, removing the need for multiple detectors and wavelength separation optics found in conventional CW laser Doppler systems. By incorporating optical fibers into the system to distribute the pulses into each channel and impose a delay between channels, the electronic requirements of such an instrument are reduced. Results for a 2D system are presented, measured on a water-seeded air jet. Individual velocity components of up to 16 ms-1 and overall velocities of up to 20 -1 have been detected, but the potential range of the instrument is very much greater.
© (1995) COPYRIGHT Society of Photo-Optical Instrumentation Engineers (SPIE). Downloading of the abstract is permitted for personal use only.
Robert A. Lockey and Ralph P. Tatam "Time-division-multiplexed laser Doppler anemometry using pulsed laser diodes and optical fibers", Proc. SPIE 2546, Optical Techniques in Fluid, Thermal, and Combustion Flow, (29 September 1995);


High-frequency pulsed-diode laser anemometry
Proceedings of SPIE (November 30 1994)
Multiplexed grating velocimetry for biomedical applications
Proceedings of SPIE (January 11 2005)
Time-division-multiplexed laser Doppler anemometry
Proceedings of SPIE (September 14 1994)
3D fiber optic Laser Doppler Velocimetry
Proceedings of SPIE (October 25 1996)
Birefringent Stress Location Sensor
Proceedings of SPIE (August 07 1986)

Back to Top