23 August 1996 Maximum transverse ray aberrations permissible in an optical system
Author Affiliations +
Abstract
This paper describes the determination and selection of tolerance values used by a tolerance based weighting program written by the authors. Equations for the amounts of low and medium order wavefront aberration permissible in an optical system are plotted as a series of wavefront and transverse ray aberration curves. This data provides the basis for a determination of individual tolerancing schemes for particular optical designs, based on their performance requirements. The maximum amount of wavefront aberration allowable in an optical system, where the required performance is limited by the maximum spatial frequency required to be passed, is also considered. These permissible wavefront aberrations in terms of reduced spatial frequency are presented as a series of curves for a range of reduced spatial frequencies s. For a tolerance-based weighting scheme it is necessary to assign a set of tolerances to each of the aberration sample sites involved in the merit function in such a way that they can be interpreted by the optimization program. The method presented in this paper is to translate the permissible wavefront aberration curves into transverse ray aberration data. In this form the data becomes accessible to transverse ray aberration based optimization algorithms.
© (1996) COPYRIGHT Society of Photo-Optical Instrumentation Engineers (SPIE). Downloading of the abstract is permitted for personal use only.
Charles D. Todd, Jonathan Maxwell, "Maximum transverse ray aberrations permissible in an optical system", Proc. SPIE 2774, Design and Engineering of Optical Systems, (23 August 1996); doi: 10.1117/12.246673; https://doi.org/10.1117/12.246673
PROCEEDINGS
18 PAGES


SHARE
KEYWORDS
Wavefront aberrations

Monochromatic aberrations

Tolerancing

Spatial frequencies

Diffraction

Wavefronts

Optical design

RELATED CONTENT

Optical design of diffraction-limited monochromatic doublets
Proceedings of SPIE (September 25 1997)
The Development Of Image Evaluation Methods
Proceedings of SPIE (June 01 1974)
Controlling surface figure errors of optical components
Proceedings of SPIE (September 09 2010)
THe Use Of O.T.F. In Optical Design
Proceedings of SPIE (June 01 1974)
Diffraction Evaluation Of General Optical Systems
Proceedings of SPIE (December 01 1978)

Back to Top