6 June 1997 Supporting results on the modeling of wave propagation and energy dissipation in joints
Author Affiliations +
Abstract
A method to characterize the energy dissipation in an overlapped bolted beam structure was derived in the first part of this paper. As a continuation of this work, a comparison of the results obtained by this methodology and the experiments used to corroborate them, are presented here. The gain of the structure (ratio of the response over the forcing function) is numerically calculated, and then experimentally verified for a high frequency content (up to 25 kHz). A linear model for the bolted joint is first assumed, and the resonant frequencies for the first twenty flexural modes are investigated. The energy flow across the jointed section is then obtained by mathematical manipulation of the power flux of the propagating waves at the connection. Thereafter, an extended nonlinear model, accounting for the nonlinear behavior of the joint, is studied in order to increase the accuracy of the method at a higher frequency range. Similar analysis of the wave interaction at the joint is also performed.
© (1997) COPYRIGHT Society of Photo-Optical Instrumentation Engineers (SPIE). Downloading of the abstract is permitted for personal use only.
Jaime Esteban, Jaime Esteban, Frederic Lalande, Frederic Lalande, Zaffir A. Chaudhry, Zaffir A. Chaudhry, Craig A. Rogers, Craig A. Rogers, } "Supporting results on the modeling of wave propagation and energy dissipation in joints", Proc. SPIE 3041, Smart Structures and Materials 1997: Smart Structures and Integrated Systems, (6 June 1997); doi: 10.1117/12.275666; https://doi.org/10.1117/12.275666
PROCEEDINGS
10 PAGES


SHARE
Back to Top