18 August 1997 Laser surface processing on sintered PM alloys
Author Affiliations +
Proceedings Volume 3097, Lasers in Material Processing; (1997) https://doi.org/10.1117/12.281107
Event: Lasers and Optics in Manufacturing III, 1997, Munich, Germany
Usually the P.M. alloys are heat treated like case hardening, gas nitriding or plasma nitriding for a better wear resistance of the product surface. There is an additional method for gaining better tribological properties and this is the surface hardening (or remelting or alloying) of the P.M. alloy by laser treatment on a localized part of the product without heating the whole sample. This work gives a cured experimentation about the proper sintering powder alloys for laser surface processing from the point of view of wear, fatigue life and surface quality. As concerns the materials three different basic alloy groups with graduated carbon contents were prepared. Regarding these sintered powder alloys one group holds Fe, Mo and C and other group holds Fe, Ni, Mo and C and the last one holds Fe, Ni, Cu, Mo and C contents. Obviously each group has a different surface hardness, different porosity distribution, different density and diverse metallurgical structures (pearlite or ferrite-pearlite, etc.). ON the sample surfaces a colloidal graphite coating, in different thicknesses, has been sprayed to increase laser energy surface absorption. On some other samples a Mo coating, in different thicknesses, has been produced (on the bulk alloy) by diverse deposition techniques (D.C. Sputtering, P.V.D. and Flame Spraying). Only a few samples have a Mo coating and also an absorber coating, that is a bulk material- Mo and a colloidal graphite coating. All these sintered alloys have been tested by laser technology; so that, many laser working parameters (covering gas, work-speed, focussed and defocussed spot, rastered and integrated beam spots, square and rectangular beam shapes and so on) have been experimented for two different processes at constant laser power and at constant surface temperature (by using a temperature surface sensor and a closed controlled link). For all experiments a transverse fast axial flow CO2 2.5 kW c.w. laser source has been employed.
© (1997) COPYRIGHT Society of Photo-Optical Instrumentation Engineers (SPIE). Downloading of the abstract is permitted for personal use only.
Wilfred Reiter, Wilfred Reiter, Giuseppe Daurelio, Giuseppe Daurelio, Antonio Domenico Ludovico, Antonio Domenico Ludovico, } "Laser surface processing on sintered PM alloys", Proc. SPIE 3097, Lasers in Material Processing, (18 August 1997); doi: 10.1117/12.281107; https://doi.org/10.1117/12.281107


Laser surface treatment prolongs tool life
Proceedings of SPIE (September 06 1994)
Laser boosted light sail experiments with the 150 kW LHMEL...
Proceedings of SPIE (September 12 2002)
Laser Heat Treatment Of Iron-Base Alloys
Proceedings of SPIE (September 29 1985)

Back to Top