Performance evaluation and optimization of a fast tool servo for single point diamond turning machines

Arthur C. Miller Jr.; James F. Cuttino

doi:10.1117/12.295136

1 November 1997 Performance evaluation and optimization of a fast tool servo for single point diamond turning machines

Arthur C. Miller Jr., James F. Cuttino

Author Affiliations +

Proceedings Volume 3134, Optical Manufacturing and Testing II; (1997) https://doi.org/10.1117/12.295136
Event: Optical Science, Engineering and Instrumentation '97, 1997, San Diego, CA, United States

Abstract

This paper describes a new, fast tool servo system designed for fabrication of non-rotationally symmetric components using single point diamond turning machines. A prototype device, designed for flexible interfacing to typical machine tool controllers, will be described along with performance testing data of tilted flat and off-axis conic sections. Evaluation data show that servo produced surfaces have an RMS roughness less than 175 angstroms. Techniques for linearizing the hysteretic effects in the piezoelectric actuator are also discussed. The nonlinear effects due to hysteresis are reduced using a dynamic compensator module in conjunction with a linear controller. The compensator samples the reduced using a dynamic compensator module in conjunction with a linear controller. The compensator samples the hysteretic voltage/displacement relationship in real time and modifies the effective gain accordingly. Simulation results indicate that errors in the performance of the system caused by hysteresis in the system can be compensated and reduced by 90 percent. Experimental implementation results in an 80 percent reduction in the motion error caused by hysteresis, but peak-to-valley errors are limited by side effects from the compensation. The uncompensated servo system demonstrated a peak-to-valley error of less than 0.80 micrometer for an off-axis conic section turned on-axis.

Citation Download Citation

Arthur C. Miller Jr. and James F. Cuttino "Performance evaluation and optimization of a fast tool servo for single point diamond turning machines", Proc. SPIE 3134, Optical Manufacturing and Testing II, (1 November 1997); https://doi.org/10.1117/12.295136

ACCESS THE FULL ARTICLE

INSTITUTIONAL
Select your institution to access the SPIE Digital Library.

SELECT YOUR INSTITUTION

PERSONAL
Sign in with your SPIE account to access your personal subscriptions or to use specific features such as save to my library, sign up for alerts, save searches, etc.

PERSONAL SIGN IN

No SPIE Account? Create one

;

PURCHASE THIS CONTENT

SUBSCRIBE TO DIGITAL LIBRARY

50 downloads per 1-year subscription

Members: $195

Non-members: $335 ADD TO CART

25 downloads per 1 - year subscription

Members: $145

Non-members: $250 ADD TO CART

PURCHASE SINGLE ARTICLE