Control of porosity in SiO2:PDMS polycerams through variations in sol-gel processing and polymer content

Tayyab I. Suratwala; Kevin Davidson; Zack Gardlund; Donald R. Uhlmann

doi:10.1117/12.284130

2 October 1997 Control of porosity in SiO₂:PDMS polycerams through variations in sol-gel processing and polymer content

Tayyab I. Suratwala, Kevin Davidson, Zack Gardlund, Donald R. Uhlmann

Proceedings Volume 3136, Sol-Gel Optics IV; (1997) https://doi.org/10.1117/12.284130
Event: Optical Science, Engineering and Instrumentation '97, 1997, San Diego, CA, United States

Abstract

A series of optically transparent SiO₂: polydimethylsiloxane (PDMS) polyceram monoliths have been synthesized by two-step acid/base sol-gel processes. Two different processing routes are discussed and compared; one synthetic route (Route 1) utilizes lower water content, shorter reflux times, and faster drying conditions compared to the other synthetic route (Route 2). The Route 1 polycerams were all essentially non-porous at all PDMS contents examined (20 - 80 volume % PDMS). In contrast, the porosity of the Route 2 polycerams varied dramatically as a function of PDMS content. The surface area and pore volume for a 0% PDMS Route 2 polyceram were 573 m²/gm and 0.59 cm³/gm, respectively; the surface area and pore volume decreased with increasing PDMS content. The amount of porosity within the polycerams is proposed to be controlled by the relative rates of condensation and evaporation during processing and by the amount of PDMS trapped in the pores. This idea is supported by the differences in the drying behavior with processing and by the structural information obtained by magic angle spinning solid-state ²⁹Si NMR of the polyceram monoliths. Quantitative evaluation of the ²⁹Si NMR and porosity data are utilized to formulate structural models of these polycerams. The structural models are then specifically used to describe the effect of porosity on the photostabilization of a laser dye doped within these polyceram monoliths.

Citation Download Citation

Tayyab I. Suratwala, Kevin Davidson, Zack Gardlund, and Donald R. Uhlmann "Control of porosity in SiO₂:PDMS polycerams through variations in sol-gel processing and polymer content", Proc. SPIE 3136, Sol-Gel Optics IV, (2 October 1997); https://doi.org/10.1117/12.284130

ACCESS THE FULL ARTICLE

INSTITUTIONAL
Select your institution to access the SPIE Digital Library.

SELECT YOUR INSTITUTION

PERSONAL
Sign in with your SPIE account to access your personal subscriptions or to use specific features such as save to my library, sign up for alerts, save searches, etc.

PERSONAL SIGN IN

No SPIE Account? Create one

PURCHASE THIS CONTENT

SUBSCRIBE TO DIGITAL LIBRARY

50 downloads per 1-year subscription

Members: $195

Non-members: $335 ADD TO CART

25 downloads per 1 - year subscription

Members: $145

Non-members: $250 ADD TO CART

PURCHASE SINGLE ARTICLE

Includes PDF, HTML & Video, when available