Translator Disclaimer
29 October 1998 Minimizing tool marks in deterministic microgrinding
Author Affiliations +
In deterministic microgrinding of glass optics with metal bond diamond ring tools, optical surfaces exhibit residual cutting tool marks that can significantly affect the efficiency of the finish polishing process. The tool marks for spherical surface generation appear as curves that follow contact lines between the tool and workpiece from the center to the edge of the workpiece. The tool marks are circumferentially periodic and the number is typically equal to the k-ratio, i.e. the ratio of grinding tool speed to workpiece speed. This paper describes the effect of the k-ratio, the tool cutting face width, and their interaction on tool mark generation. We introduce a new parameter equal to the ratio of tool cutting face width to the k-ratio spacing. Experimental results indicate that this ratio is the critical factor for tool mark generation. For ratios greater than a critical value, the amplitude of tool marks will be reduced to a level not detectable by interferometry. The influences of vibration and tool roughness are also discussed. The model presented provides new insight into the generation of tool marks and optimization of deterministic microgrinding processes.
© (1998) COPYRIGHT Society of Photo-Optical Instrumentation Engineers (SPIE). Downloading of the abstract is permitted for personal use only.
Yi Li, Sheryl M. Gracewski, Paul D. Funkenbusch, and Jeffrey L. Ruckman "Minimizing tool marks in deterministic microgrinding", Proc. SPIE 3429, Current Developments in Optical Design and Engineering VII, (29 October 1998);


Ultrasonic precision optical grinding technology
Proceedings of SPIE (October 11 2015)
Deformation of fused silica: nanoindentation and densification
Proceedings of SPIE (September 23 1998)
Finish machining of optical components in mass production
Proceedings of SPIE (March 01 1991)
The Optical Element Fabrication Process
Proceedings of SPIE (September 16 1980)

Back to Top