Translator Disclaimer
Paper
13 November 1998 Design, analysis, and performance of an epoxy-bonded bendable mirror
Author Affiliations +
Abstract
The toroidal, silicon mirror on microdiffraction beamline 7.3.3 at the Advanced Light Source provides a 1:1 focus of the bend magnet source. The mirror is bent by two lead springs that are bolted to it through a pari of adhesive bonded end blocks. Because of the high loads that these adhesive joints must carry, three specific features of the bonds were tested: bondline geometry of the mating end blocks, surface preparation of the adherends, and strength of the adhesive. Bond strengths were evaluated by loading small test mirrors to failure using two epoxies under two different conditions of surface preparation - acid etching and simple UHV cleaning. In addition, the mirror's temperature distribution and figure errors were calculated with an Ansys Finite Element Model. The model's predictions were correlated to long trace profilometry as well as x-ray focus measurements.
© (1998) COPYRIGHT Society of Photo-Optical Instrumentation Engineers (SPIE). Downloading of the abstract is permitted for personal use only.
Neal D. Hartman, Philip A. Heimann, Alastair A. MacDowell, Keith D. Franck, Andrew P. Grieshop, Steven C. Irick, and Howard A. Padmore "Design, analysis, and performance of an epoxy-bonded bendable mirror", Proc. SPIE 3447, Advances in Mirror Technology for Synchrotron X-Ray and Laser Applications, (13 November 1998); https://doi.org/10.1117/12.331128
PROCEEDINGS
12 PAGES


SHARE
Advertisement
Advertisement
RELATED CONTENT

Active microstructured x-ray optical arrays
Proceedings of SPIE (April 30 2009)
Single two-axis micromachined tilt mirror and linear array
Proceedings of SPIE (January 20 2003)
Reaction bonded silicon carbide gimbaled pointing mirror
Proceedings of SPIE (September 17 2007)
Thermal deformations of a cooled x-ray mirror
Proceedings of SPIE (November 21 1996)
JWST NIRCam flight mirror assemblies
Proceedings of SPIE (September 28 2011)

Back to Top