Translator Disclaimer
27 August 1998 Plasma damage monitoring for PECVD deposition: a contact potential difference study and device yield analysis
Author Affiliations +
A study was conducted to monitor plasma induced charging during a plasma enhanced chemical vapor deposition (PECVD) process. A contact potential difference (CPD) technique was used for the charge measurement on non-device blank wafers. In two TEOS based PECVD SiO2 deposition processes, one phosphorous doped and one undoped (USG), the plasma induced charging behavior was monitored while deposition conditions were varied. It was found that the process deposition pressure had a large effect on the plasma induced charging behavior. For both the PSG and the USG deposition processes, higher pressure process regimes offered significantly improved plasma charging performance than the conventional low pressure regimes. The CPD was reduced from -13.5V to 1.5V for the PSG process, and the CPD uniformity was reduced from 8.17V to 2.39V for the USG process. The improved deposition process conditions were tested on thin gate antenna test structures and correlated to significant improved device yield. Additionally, a plasma assisted de- chucking process was analyzed using the CPD technique and found to be an important source of plasma induced charging. When test were performed on thin gate antenna test structures the CPD again correlated well yield trends. In summary, the study demonstrated that CPD is a powerful, inexpensive, and rapid technique suitable for developing processes with improved gate oxide yield and for in-line monitoring of chamber performance.
© (1998) COPYRIGHT Society of Photo-Optical Instrumentation Engineers (SPIE). Downloading of the abstract is permitted for personal use only.
Zhiwei Xu, Christopher Bencher, Maggie Le, and Chris Ngai "Plasma damage monitoring for PECVD deposition: a contact potential difference study and device yield analysis", Proc. SPIE 3509, In-Line Characterization Techniques for Performance and Yield Enhancement in Microelectronic Manufacturing II, (27 August 1998);

Back to Top