Control of defects on photomasks is becoming increasingly critical with smaller geometries, tighter specifications and optical proximity control (OPC). Additionally there are new phase shift (PSM) mask materials which are difficult, if not impossible to repair wit today's equipment. This paper reports on using the KLA-Tencor STARlight SL 300 in several applications to improve first pass defect levels on photomasks. Two tests were run in which fully exposed reticles were inspected at several points in the PBS process to determine which process caused hard chrome defects at final inspection. In the first test, of 23 final defects, 9 were first seen after exposure, 2 after develop and 12 after bake. In the second, of 9 final defects, 6 were seen on raw blank, 1 after exposure and 2 after develop. Also reported is the use of the SL 300 to assist in an iterative process/equipment improvement for a strip cycle, resulting in 0 post strip defects in clear areas >= 0.5 micrometers . Finally, raw mask blank inspection prior to writing is discussed. Data is presented on a lot of 10 plates in which 50 percent of the pates inspected did not mete the specification of 0 defects >= 1.0 micrometers . The use of the SL 300 to 'cherrypick' blanks for difficult layers is discussed.